Din hobby pentru electronice
English  

Vizitatori online

In prezent sunt 12 vizitatori online.

Electronic Brick - Big Button


6,72RON cu TVA  4,44RON cu TVA
Save: 34% off


Modul buton, compatibil cu platformele de dezvoltare Arduino (sau clone).

  Electronic Brick

By using electronic bricks, you may connect Arduino compatible boards easily with various digital, analog and I2C/Uart interfaces. These the breadboard-less firm connection are prepared to extensive modules like poteniometers, sensors, relays, servos...even buttons, just plug and play. 

Each terminal module has buckled port with VCC, GND and Output, which has corresponding port on the sensing board, with a plain 2.54mm dual-female cable you may start playing already. Buckled brick cables are like cement for bricks, make the connections easier, secure and more professional looking.

EB

  Overview

A simple obvious button that fits finger pad rather than nails.

When you connect the + and - pins to power supply, you can use this to get the digital signal output from S pin. It's high level when the button releases, and it will output low level when the button is pressed.

 

 Programming

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
int Button=2;
int LED=13;
void setup()
{
 pinMode(LED, OUTPUT);
 pinMode(Button, INPUT);
  
}
 
void loop()
{
  
if (digitalRead(Button)==HIGH)
 {
 digitalWrite(LED, HIGH);
  
 }
  
 if (digitalRead(Button)==LOW)
 {
 digitalWrite(LED, LOW);
 }
 
}
 

Specification

Brick Type:  Button and Switch
Brick Interface:  3PIN
Brick Power Supply:  5V
Board Size:  37 × 21 × 1.6mm
Weight:  20.00g

 
  • 29 Bucati in stoc

Fii primul care scrie un review.  Scrie un review de produs.

Produsul a fost adaugat in data de Monday 07 May, 2012.



UV Sensor
33,63RON cu TVA
RS485 Shield
49,90RON cu TVA
Beetle
35,00RON cu TVA